Ghz Operation Notes - R2hobbies.com Eurgle Instruction Manual

 2.4Ghz Operation Notes
 Matching (Code)
Our products are well matched in the factory; you do not need to match by yourself. But if your are
going to match the receiver with other transmitter or you needs to change a new receiver or
transmitter, please follow the following steps:
1. Install the battery to 2.4G transmitters and shut it down.
2. Insert the matching lines to the channel BIND / CH3 port of the receiver.
3. Connect the receiver battery to VCC port of the receiver, on the same time the two LED are
flashing and this means the receiver are going to the matching status
4. Press and hold the button on the transmitter, and then switch on the power supply.
5. Observe the LED on the receiver, if find that the LED is not flash anymore and that means
successful Matched.(This process will take about 5 seconds)
6. Release the match button on the transmitter, takes out the match line.
7. Install the server and then test.
8. If the tests fail, please repeat the action above.
9. If the tests success, then insert the power supplies port into VCC, match complete.
 Power ON
1. Connect every part
2. Switch on the power supply of the transmitter
3. Connect the power supply of the receiver
4. Receiver LED Light Solid
5. Finish and Use
 Shut Down
1. Cut off the receiver power supply
2. Cut off the transmitter power supply
Join our FREE Membership and accept 10%off Offer!
Eurgle 2.4Ghz 3 Ch LCD Wheel
Digital Programmable Radio Gear
rcps2805004
R2hobbies.com