Timer Operation; Example Of Timer Setting - Magnavox RG51B1 Manual

Timer operation

To set the Auto-on time.
1. Press the TIMER ON button. The remote
control shows the previous Auto-on setting
SET TEMPERATURE( C)
time and the symbol "h" on the LCD display.
AUTO FAN
COOL HIGH
DRY MED
2. Push the TIMER ON button again to set desired
TIMER ON
HEAT LOW
Auto-on time. Each time you press the button,
TEMP
the time increases in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24
ON/OFF
MODE hours.
FAN SPEED
SWING TIMER ON
ECONOMY
1
3. After setting the TIMER ON ,there will be a slight
delay before the remote control transmits the
TIMER OFF
RESET LOCK
2
signal to the air conditioner. Then, after approximately
LED
DISPLAY
2 seconds, the symbol "h" will disappear and
the set temperature will show on the LCD display.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
control shows the previous Auto-off setting
time and the symbol "h" on the LCD display.
2. Push the TIMER OFF button again to set desired
Auto-off time. Each time you press the button,
the time increases in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER OFF, there will be a
slight delay before the remote control transmits
the signal to the air conditioner. Then, after
approximately 2 seconds, the symbol "h" will
disappear and the set temperature will show
on the LCD display.
9
IMPORTANT
The effective operation time set by the remote control for the timer
function is limited to the following settings: 0.5, 1.0, 1.5, 2.0, 2.5, 3.0,
3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13,
14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24.

Example of Timer setting

TIMER ON
(Auto-on Operation)
The TIMER ON feature is useful when you want
h
the unit to turn on automatically. The air conditioner
TIMER ON
will automatically start operating at the set time.
Start
Example:
Off
To start the air conditioner in 6 hours.
1. Press the TIMER ON button, the last setting of
Set
6 hours later
starting operation time and the symbol "h" will
show on the display.
2. Press the TIMER ON button to display "6:0h" on
the TIMER ON display of the remote control.
3. Wait for about 3 seconds and the digital display
area will show the temperature again. This shows
that the function is activated.
10