Replacing Batteries - Magnavox RG51B1 Manual

CONTENTS
Using the Remote Control ............................................................
Remote Control Technical Specifications....................................
Button Functionality.................. ....................................................
Reading the LCD Display ..............................................................
Remote Control Button Instructions ...........................................
AUTO Mode.....................................................................................
COOLING/HEATING/FAN Mode.....................................................
DEHUMIDIFIER Mode ....................................................................
SWING Mode...................................................................................
TIMER Mode....................................................................................
ECONOMY Mode.............................................................................
2
3
4
6
7
7
7
8
8
9
12
1
Using the Remote Control
Proximity of remote control and unit.
Use the remote control within a distance of 26 feet
from the unit, pointing it towards the receiver.
Button pushes are confirmed with beeps.
26 ft.
CAUTION
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote control to the indoor unit.
Prevent any liquid from going into the remote control. Do not expose
the remote control to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote control, either move
these appliances or consult your local dealer.

Replacing batteries

The remote control is powered by two AAA
batteries housed in the rear cover.
(1) Remove the cover by pressing and sliding out.
(2) Remove the old batteries and insert the new
batteries,placing the(+) and (-) ends correctly.
(3) Reattach the cover by sliding it back into
position.
.
NOTE: When the batteries are removed,
the remote control resets all programming.
The remote control must be reprogrammed
again.
2