Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Enerpac XC-Series
Summary of Contents for Enerpac XC-Series
- Page 1 XC-Series Cordless Hydraulic Pump Instruction Manual...
-
Page 2: Table Of Contents
Do not remove relief valve. operation. Save these instructions. Operation ENERPAC cannot be responsible for damage or Disconnecting To avoid personal injury keep hands and feet away from cylinder and injury resulting from unsafe product use, lack of work piece during operation. - Page 3 Non genuine ENERPAC parts may break, causing personal injury Avoid sharp bends and kinks when routing hydraulic hoses. and property damage. ENERPAC parts are designed to fit properly and Using a bent or kinked hose will cause severe back-pressure.
-
Page 4: Electrical Safety
To avoid accidental starting, when carrying or moving the pump ensure the safety switch is in the locked position, and do not carry with hand or fingers on the trigger. Do not operate pump if safety switch does not function. Seek repair assistance from an ENERPAC service center. -
Page 5: Installation
Installation 11/16" 3/8” NPTF 60 - 70 Nm Gauge Recommended & 15/16" 44 - 53 ft lb 60 Min = 100%... -
Page 6: Use
Optional Strap Shown... -
Page 7: Operation
Operation... -
Page 8: Disconnecting
Disconnecting... -
Page 9: Oil Fill
Oil Fill 1/4" < Ø13mm 4.5 - 5.7 Nm 1/4" Pour slowly 40 - 50 in lb... -
Page 10: Pressure Setting
Pressure Setting Factory Setting User Adjustable = 700 bar/10,000 psi/70 MPa Flat head screwdriver 7/32" x 6" = 700 bar/10,000 psi/70 MPa = 150 bar / 2,175 psi / 15 MPa... -
Page 11: Technical Specifications
Technical Specifications Usable Oil Capacity Weight Charger Voltage Cylinder / Tool Valve Model Number 1 PH, 50/60Hz * Litres in³ 21.9 XC-1201MB 115 V 10,8 23.8 XC-1202MB 21.9 XC-1201ME 230 V Single acting Manual 3 way, 2 position 10,8 23.8 XC-1202ME 21.9 XC-1201M**... -
Page 12: Troubleshooting
Battery pack discharged. Charge battery. Pump will not start. Battery pack shut off. Refer to battery/charger instruction sheet. Brushes worn. Contact ENERPAC service center. Trigger lock engaged. Undo trigger lock. Motor damaged. Contact ENERPAC service center. Electrical contacts dirty or corroded. - Page 14 +86 400 885 0369 Republic of South Africa L4004_b sales-cn@enerpac.com 0027 (0) 12 940 0656 Rev. B/04/2013 sales-za@enerpac.com 331-0821 85-7 Tel 048 662 4911 e-mail: info@enerpac.com Fax 048 662 4955 Internet: www.enerpac.com enerpac@apj.ne.jp ENERPAC © 2013 - Subject to change without notice.
Need help?
Do you have a question about the XC-Series and is the answer not in the manual?
Questions and answers