Miele T 8860 WP Operating Instructions Manual page 33

Problem
The Clean the filters
indicator light
comes on at the end
of the programme.
~F~ appears and a
programme cannot
be started
Bars are flashing at
the end of the
programme:
—œ–...C~–...Cœ˜...
The programme will
be cancelled.
The buzzer may
sound and Cooling
down or Finish may
also flash in the
display.
The Start/Stop
indicator light is
flashing slowly and
the display is dark.
The Start/Stop
button flashes/does
not flash.
Possible cause
This is a reminder to
clean the fine filter in front
of the heat exchanger unit
under running water.
The fine filter is missing or
has been replaced the
wrong way round.
Removing the filter during
a drying cycle will cause
the programme to be
cancelled. Cooling down
flashes.
The programme has
finished but the laundry is
still being cooled down.
No obvious cause.
The dryer is in Standby
mode.
This is quite normal and
not indicative of any fault.
The flashing indicates
that a programme can be
started.
Problem solving guide
Remedy
– Clean the fine filter.
– See "Cleaning and care".
To switch off the Clean the
filters indicator light:
– Remove, clean and replace
the fine filter with the
tumble dryer switched on.
– Replace the fine filter
correctly. ~F~ goes out.
– See "Cleaning and care".
– Replace the fine filter.
– Switch the dryer off and
back on again.
You can either unload the
drum and leave the laundry to
cool at room temperature or
leave it in the dryer to
continue cooling.
– Switch the dryer off and
back on again.
– Then start the programme
again.
If this problem happens
again, there is a fault. Contact
Miele Service.
See "Setting standby" in
"Programmable functions"
After the programme has
started, the flashing will
change to a constant light.
33