J24 Ð Hdd Led Connectors; Ide1/Ide2 Ð On-Board Primary/Secondary Ide Hdd; Connectors; Ir Ð Ir Connector - SOYO 82430 TX PCI Users Manual And Technical Reference

18
Hardware Setup
J24 – HDD LED Connectors
Attach the cable of hard disk drive LEDs to this connector. The LED
lights when an HDD is active.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD

Connectors

Attach cables of hard disk drives to these connectors.
IR – IR Connector
Attach a 5-pin infrared device cable to this connector for enabling the
infrared transfer function. This mainboard meets the specification of
ASKIAR and HPSIR.
J17 – Keylock & Power LED Connector
J17 is a connector for a lock that may be installed on the system case for
enabling or disabling the keyboard. J17 also attaches to the caseÕs Power
LED. (Pin 1, 3 for power LED and pin 4, 5 for keylock.)
CN2 – PS/2 Keyboard Connector
A PS/2 keyboard connector is located at the rear of the board. Plug a 6-
pin male PS/2 keyboard connector to this connector.
CN1 – PS/2 Mouse Connector
Attach 6-pin male PS/2 mouse connector to this connector.
PRT – Parallel Port Connector
Attach parallel port cable to this connector.
J18 — Speaker Connector
Attach a 4-pin case-mounted speaker to this connector.
J22 – Turbo LED Connector
Attach the turbo LED to J22. The LED lights when the system is in
Turbo mode.
USB1 – Universal Serial Bus Connectors
Attach 9-pin USB cable to these connectors for external USB device.