Tools; Battery - Skyteam ST50-8 Operation Instruction Manual

NOTES:
(1)This table is a reference for periodic maintenance, ideally more checks and maintenance should be
carried out.
(2)"Check" in the table contains cleaning, adjusting, lubrication and changing.
(3)Ask for a professional repairer when you can not treat any items by yourself.
(4)The intake and exhaust valves should be checked after every 1,600km. The valve clearance in cold
state is 0.05mm.
(5)After worn, the limiting thickness of the upper plate of the brake shoe is 1.5mm. The brake shoes
should be replaced in full sets.
(6)Checks should often be made to see the swing condition of the front and rear wheels. If the wheel
swing seriously, find out the reason and conduct troubleshooting.
**The steel rim and hub in front and rear wheel assemblies are connected by four connecting bolts(M8X16-
Zn.D), whose tightening torque value is 18-25N.m.
In the periodic maintenance you may need to change one or more parts. We suggest you to
use Skyteam spare parts. We suggest you to go to qualified Skyteam service station for
maintenance to the items with "*". For other items, you may check and maintain for yourself.
NOTE
28

TOOLS

To help you to implement the periodic maintenance, we supply you with a tool kit which is placed in the
small bag below the rear side of the frame.
LUBRICATING
In order to keep every part of your motorcycle performing well and extend their service life, you should
do proper for your driving. After driving on rainy day or washing the motorcycle, you are required to apply
the lubrication on the necessary parts. The main places to be oiled are drive chain, brake cable, front
brake lever and kick start lever pivot.

BATTERY

This battery is 12V-4Ah dry and needn't to be maintained, so it doesn't
have to be checked and supplied with electrolyte.
When the left side cover of motorcycle is opened, the battery (1) and
fuse (2) can be seen.
Pls cover the lid 25minutes after adding the electrolyte, when the battery
is used for the first time. The voltage should be higher than 12.5-12.6volt
when measured by the multi-meter. If the voltage is lower than the
stipulated data, pls change the battery with the accumulator.
If the manufacturing date is before two years, the battery must be charged when it's the first time to use.
ATTENTION
29