Highland Ridge RV 2015 Owner's Manual page 54

SECTION 5 - SLIDEOUT SYSTEM
After the slideout is extended, verify that the corners of the black rubber seal are
set up correctly. The corners of this seal are cut at a 45° angle. The top of the seal
must overlap the side of the seal to avoid the possibility of water penetration.
Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and
motor.
Maintenance
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have
been disconnected.
5-2
Fig. 5.1 Monitor Panel
Fig. 5.2 Slideout overlap
WARNING
HIGHLAND RIDGE TOWABLE