In These Cases - Citizen Eco-Drive AP2XXX Instruction Manual

IN THESE CASES

When shown the Insufficient Charge Warning
Display
If the watch is put in the undercharged
state during any display mode, it
switches to the time display when in
other display modes, then the second
hand moves to the
position, indicating insufficiently
charged.
In such a case, expose the watch to sufficient light
for the warning state to be cancelled. (The second
hand returns to 1 second movement)
It takes about 30 minutes to complete charging;
from starting to expose the watch to light until this
warning state is cancelled. The charging time varies
depending on the light (light source) that radiates
over the watch.
When Shown the Stop Warning Display
If the watch is left intact in the
undercharged state, about 5 days
later the second hand will move to
the STOP position, indicating that
the watch has stopped due to
insufficient recharge.
* All functions are stopped in this state.
In such a case, expose the watch to sufficient light
for the warning state to be cancelled.
After carrying out sufficient charging, it is necessary
to reset the alarm time.
When Shown the Time Setting Warning Display
If you expose a watch which has
stopped once to light and recharge it,
the second hand will move to the
SET position to let you know that the
time is incorrect.
In such a case, readjust the hour,
minute and 24-hour hands to keep
the correct time.
Without adjusting the time hands after the watch is
fully recharged, you cannot use such functions as
alarm, chronograph, etc. properly.
* Be careful because if the watch is not sufficiently
charged during the Time Setting Warning Display
state, and if light is blocked from it, the second
hand will change to the
watch will stop running.
CHARGE
STOP position and the
CHECKING AND ADJUSTING EACH HAND'S
"0" POSITION
The watch's display may go wrong due to the effect
of static electricity, strong shock, etc.
In such a case, check and adjust the "0" postion of
each of the following hands.
"0" Position Checking
1. Press button
mode hand at <CHR> position
for chronograph function.
2. Pull out button
and check to see if each hour,
minute, second, 24-hour and
function hands quickly moves
to "0" position (12 o'clock position) while date
hand quickly moves to "1" position.
If any hand returns wrong out of the correct
position "0" or "1", the watch needs ["0" position
adjustment].
"0" Position Adjustment
1. For adjusting the second hand
to "0" postion:
• Press button
2. For adjusting hour, minute and
24-hour hands to "0" position:
• Press button
3. For adjusting date and function
hand to position "1" and "0" respectively:
• Press button .
B
• "0" position for function hand is equivalent to
12 o'clock position just after the date has been
set at "1" position.
• With four turns of a function hand, date indication
is adjusted by a day.
• If button , or
A C B
hand corresponding to the button moves quickly.
4. When "0" position adjustment is complete, push
button into the original position.
M
* Make sure to reset time, calendar, alarm time
correctly following "0" position adjustment.
to set the
M
by one click
M
.
A
.
C
is continuously pressed, the