Using The Alarm; Using The Chronograph - Citizen Eco-Drive AP2XXX Instruction Manual

USING THE ALARM

The alarm sounds once a day
for 15 seconds at the alarm
time set.
Pressing any buttons
C
Setting the Alarm
Alarm setting is on a 24-hour system in 1 minute.
The hands are moved thus: minute hand ➝ hour
hand ➝ 24-hour hand.
1. Press button to set the mode hand to <ALM>
M
and switch to the alarm mode.
2. Pull button out, to the alarm set time adjusting
M
state.
3. Press button or
B C
24-hour hands to the desired time.
• Each time button
B
advances 1 minute in a clockwise direction.
• Each time button
C
back 1 minute in a counterclockwise direction.
* Depress button or button
B
hands move rapidly.
Switching the Alarm ON and OFF
Each time button is pressed in the alarm mode,
A
the alarm switches ON and OFF.
Alarm Sound Monitor
On the alarm mode (button
pressing button will sound the alarm for 5
A
seconds.
NOTE
• There may be some variation in the volume of
the alarm sound, depending on how much the
second battery is charged.
• The alarm sound volume gets rather lower in the
displays other than the time display (calendar,
alarm, chronograph, "0" position confirmation,
and each display's adjustment state).
Once the alarm time has been set, use the watch
normally in time display mode.

USING THE CHRONOGRAPH

Chronograph measurement is taken in 1/20 (0.05)
seconds and can continue for 60 minutes max. Over
60 minutes, the watch enters the chronograph reset
state.
,
A
stops the alarm ringing.
to set the minute, hour and
is pressed...The watch
is pressed...The watch turns
continuously, the
C
in normal position),
M
Reading the Chronograph Hands
• Function hand ➝ Chrono minutes or Chrono 1/20
seconds.
* The function hand moves every one minute.
or Pressing button
B
display, switches the function hand to show
chrono 1/20 seconds.
• Second hand ➝ Chrono second hand.
Chronograph Measurement
* The hour, minute and 24-hour hands show the
present time.
2. Each time button
starts or stops the chronograph, along with a
confirmation sound.
How to read each chronograph hand if the
measured time when the chronograph is stopped is
over 1 minute.
➀ Read the number of minutes with the function
hand
➁ Read the number of seconds with the second
hand.
➂ While pressing button
hand switches to 1/20 (0.05) second hand
measurement, so read the value at that time.
When button
resumes showing chronograph minutes.
3. While the chronograph is stopped state, pressing
button
C
second hand to the 0 position.
Chronograph Split Measurement
Pressing button
measurement causes the chronograph split time to
appear on display with a beep for confirmation.
Press button
time is displayed, along with a confirmation sound.
The split time display is automatically cancelled
after about 10 seconds, and the chronograph
returns to the measurement state.
During either chronograph split time display or
measurement, pressing button
chronograph stop to appear on display.
In the chronograph stop state, pressing button
causes the chronograph reset.
while in chrono stop or split
B
Chronograph standard or
accumulated elapsed time
measurement
1. Press button
mode hand to <CHR> and
get the chronograph display.
At this time, the second
hand and the function
hand will return to the "0"
position.
is pressed, it repeatedly
A
continuously, the function
B
is released, the function hand
B
resets the function hand and the
during chronograph
C
again, the next chronograph split
C
causes the
A
* During split time
measurement or while
split time display, each
time you press button
the next split time is
displayed.
to set the
M
C
C