Advertisement
Fitting and Removing the Hood
8
fig. 24
fig. 25
To fit the hood, place the hood on the chassis, inline with the seat unit. Clip the hood
catches onto each side of the chassis and secure with hook and loop fastener (fig.24-26).
To remove the hood, do the reverse of the above.
Adjusting the Hood
fig. 27
fig. 28
To open or close the hood, pull or push the hood, as shown. (fig.27-29).
www.obaby.co.uk
fig. 26
fig. 29
fig. 30
fig. 31
Press
fig. 33
fig. 34
To fasten the harness, insert both fasteners on the waist
strap into the clasp on the crotch strap (fig.30). Then clip
each shoulder strap onto the waist strap (fig.31 & 32).
To release the harness, press the button in the centre of
the clasp and remove the waist strap fastners (fig.33).
Adjust the harness length using the buckles on each strap
(fig.34).
'D' Ring
The 'D' rings highlighted are provided for fitting a separate
harness complying with BS 6684 (fig.35).
When using the safety harness from birth, it may be
necessary to use the lower holes for the shoulder strap and
the inner holes for the waist straps and crotch strap.
Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap
should be used when your child is of a suitable size. (See fig.A)
WARNING:
Always use the crotch strap in combination with
the waist belt
www.obaby.co.uk
Using the Harness
9
Shoulder
Strap
Clasp
Crotch
Waist
Strap
Strap
fig. 32
fig. 35
Upper
Lower
Outer
Outer
Inner
Inner
Outer
Harness
Positions
fig. A
Advertisement
