Recording In Natural Colors (White Balance); Adjusting White Balance Manually - Panasonic Palmcorder Multicam PV-DC152 Operating Instructions Manual

2, 3
1
1AWB
1
1
3
2
1
4 5
2, 3,
4
1
1
MNL
2
1
10 000K
9 000K
8 000K
7 000K
6 000K
5 000K
1)
6)
4 000K
7)
3 000K
8)
9)
2 000K
10)
1 000K
26
Recording in Natural Colors
Depending on the scene or light conditions, the Automatic White Balance
Adjustment Mode may not be able to bring out natural colors. In such a case,
the white balance can be adjusted manually.
1
2
3
1
Automatic White Balance Adjustment [AWB]
2
Indoor Mode (shooting under incandescent lighting) [{]
3
Outdoor Mode [z]
4
Fluorescent light Mode [|]
5
The White Balance setting that was previously set manually [1]
To Resume Automatic Adjustment
1
Rotate the [PUSH] Dial until the [AWB] Indication appears. Or, set the Mode
Selector Switch to [AUTO].
≥When power is turned on with the Lens Cap on, the Automatic White
1
Balance Adjustment may not function properly. Please turn on the
Palmcorder after removing the Lens Cap.
≥For other notes, see page 57.
~~~~~~~~~~~~~~~~~~~~~~~~

Adjusting White Balance Manually

When the Auto White Balance Adjustment function does not operate suitably
under the existing light conditions, use the Manual White Balance Adjustment
mode.
1
2
3
4
To Resume Automatic Adjustment
Rotate [PUSH] Dial until the [AWB] Indication is displayed. Or, set the Mode
Selector Switch to [AUTO].
3
ª About White Balance Sensor
The White Balance Sensor
during recording.
≥Do not cover the White Balance Sensor with your hand during recording.
2)
Otherwise, White Balance will not work normally.
Use of Auto White Balance Adjustment in inappropriate lighting conditions
3)
may result in reddish or bluish images. Where the subject is found on the left,
4)
but surrounded by many light-sources, Auto White Balance Adjustment may
not operate properly. In such a case, we suggest that you adjust the White
5)
Balance.
1) The range that is controlled by the Auto White Balance Adjustment Mode
2) Blue sky
3) Cloudy sky (Rain)
4) TV screen
5) Sunlight
6) White fluorescent light
7) Halogen light bulb
8) Incandescent light bulb
9) Sunrise and sunset
10) Candlelight
≥For other notes, see page 57.
Set the Mode Selector Switch to [MANUAL].
≥The [MNL] Indication appears.
Press the [PUSH] Dial.
≥The [AWB] Indication appears.
Rotate the [PUSH] Dial to set a desired White Balance Mode.
Set the Mode Selector Switch to [MANUAL].
1
≥The [MNL] Indication
Press the [PUSH] Dial.
≥The [AWB] Indication appears.
Rotate the [PUSH] Dial until the [
displayed.
Point the Palmcorder at a full-screen white subject, and then
keep the [PUSH] Dial pressed until indication [
flashing.
≥When the [1] indication flashes after turning the Palmcorder on, the
previously adjusted white balance setting is still kept.
3
of this Palmcorder
(White Balance)
appears.
1
] indication
determines the nature of the light source
2
is
1
] stops