Table of Contents
Advertisement
Operating
Using the magnify feature
1.
Press the MAGNIFY ON button on the remote control.
The picture will be magnifi ed, and the MAGNIFY dialog will
appear on the screen. When the MAGNIFY ON button is
pressed for the fi rst time after the projector is turned on, the
picture will be zoomed by 1.5 times. On the dialog, triangle
marks to show each direction will be displayed.
2.
The display magnifi cation of the projector switches in order
with every press of the MAGNIFY ON button.
For computer signals, HDMI
LAN, USB TYPE A or USB TYPE B port
1.5 times 2 times 3 times 4 times 1 time
For video signals, s-video signals, component video signals or HDMI
(Component) signals
1.5 times 2 times 1 time
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magnifi cation.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnifi cation is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnifi cation is active, the keystone distortion condition may vary.
It will be restored when the magnifi cation is disabled.
● Some horizontal stripes might be visible on the image while magnifi cation is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
(RGB) signals, input signals from the
TM
MAGNIFY
ON/OFF button
VIDEO
COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT
AUTO
SEARCH
BLANK
MAGNIFY
FREEZE
PAGE
VOLUME
UP
ON
＋
OFF
DOWN
ー
MY BUTTON
KEYSTONE
MUTE
1
2
POSITION
MENU
ENTER
ESC
RESET
TM
27
Advertisement
Table of Contents
