Canon Vistura Instruction Manual page 10

Charging and attaching the battery pack
E
You will have to charge the battery pack before you can use it. A brand new battery pack must be charged
twice before use.
1. Slide the battery pack onto the adapter as shown.
• Make sure the DC coupler is not connected.
2. Plug the adapter into an AC outlet.
• The CHARGE/REFRESH indicator flashes red to show that charging is in progress.
3. Wait until the battery pack is fully charged.
• The indicator glows steadily red when the battery pack is fully charged.
4. If the battery pack is brand new, take it off the adapter, then slide it on again and charge
it one more time.
5. Take the battery pack off the adapter and attach it to the camera.
• Insert the end marked with a triangle first, then press in the battery pack until it clicks and locks into
place.
6. Detach the battery pack after use.
• Press and hold the BATTERY EJECT button while you pull the battery pack outwards from the rear.
• Always turn the camera off before removing the power source.
Charging and recording times
BP-711 Battery Pack
Charging time
Continuous recording time
• These times vary — the safest policy is
always to have two or three times as many
battery packs as you think you will need.
10
1
2
70 minutes
60 minutes
5
NOTE FOR CUSTOMERS IN THE USA AND
NICKEL-CADMIUM BATTERY.
MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
FOR MORE INFORMATION,
PLEASE CONTACT YOUR LOCAL
ENVIRONMENTAL AGENCY.
RBRC RECYCLING SYSTEM IS AVAILABLE IN
THE USA AND CANADA.
6