Connecting To A Digital Tv Receiver - JVC I'Art 0506TNH-II-IM User Manual

Connecting to a Digital TV Receiver

By connecting a Digital TV Receiver, high definition pictures can be displayed on your TV in
their digital form.
TV Rear Panel
1
DIGITAL-IN
2
1) Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to
the DIGITAL-IN 1 on the back of your television.
2) Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO INPUT
"INPUT-3" on the back of your television.
3) Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO INPUT
"INPUT-3" on the back of your television.
• The digital-in terminal is not compatible with the picture signal of a personal computer.
• Use a HDMI to DVI cable (commercially available) in order to digitally connect the television
with a DTV decoder.
Notes:
• If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance
may be slightly shifted. Access the "Digital-In Size" in the External Input menu to adjust it.
(Refer to page 44.)
• When you do the above connection, set "Digital-In1 Audio" in the External Input menu to
ANALOG. See "Digital-In1 Audio", page 44.
• The Analog Audio input can only be used with the HDMI 1 input.
• When setting the "DIGITAL AUDIO – ANALOG / DIGITAL" menu setting on the TV, please note
that this setting only effects the HDMI 1 jack and that if you use a DVI to HDMI adapter this
connection must be made to the HDMI 1 along with analog audio cables.
INPUT-3 INPUT-2 INPUT-1
S-VIDEO S-VIDEO
OVER OVER
VIDEO VIDEO VIDEO
L L L
AUDIO AUDIO AUDIO
R R R
After the connections have been made,
tighten the screw to secure the cables.
Quick Setup
DTV device
Audio Out
L R
HDMI to DVI Cable
Digital Out
17