Connecting Headphones - JVC HV-L29PRO Instructions Manual

Connecting methods
1 Connect the TV's VIDEO jack
and the device's VIDEO OUT
(video output) jack with a video
cable.
If connecting a device to the TV
with an S-VIDEO cabel :
Connect the VCR's S-VIDEO OUT (S-VIDEO
output) connector and the TV's S connector
with an S-VIDEO cable, instead of connect-
ing with a video cable.
Note that the connection with a video cable
will be ignored in case you conect a VCR to
the TV with both video cable and S-VIDEO
cable.
If connecting a DVD player to the
TV with a component video
cable.
Connect three jacks (Y/VIDEO, C
the VIDEO-3 terminal and the DVD player's
COMPONENT (component video output)
jacks with a component video cables,
instead of connection with a video cable.
Then set the VIDEO-3 SETTING to COMPO-
NENT, according to "VIDEO-3 SETTING" on
page 28.
• This Television is compatible with the
Progressive video signal (525P signal).
(When the component video signal is
input.)
If you have a DVD player that outputs
Progressive video signals (525P) as a
component video signal, then by
attaching the device to the television with
a component video cable you can see
the actual images that are recorded on a
DVD disc as an original image source.
If connecting a device to the
VIDEO-3/COMPONENT terminal
with a video cable.
Connect the TV's Y/VIDEO jack and the
device's VIDEO OUT (video output) jack with
a video cables.
Then set the VIDEO-3 SETTING to VIDEO
according to "VIDEO-3 SETTING" on page
28.
• In the VIDEO-4 terminal, the VIDEO jack
is indicated by "V".
2 Connect the TV's AUDIO jacks
(L/MONO and R) and the
device's AUDIO OUT (audio L/R
output) jacks with an audio
cable.
If the device's sound output is in
mono :
Connect the device's AUDIO OUT jack and
the TV's L/MONO jack with an audio cable.
• In the VIDEO-4 terminal, the AUDIO
jacks is indicated by "R".
Connecting devices to the
OUTPUT terminal
The signals of the images and sound you are
and C ) in
currently viewing with this TV are output
B R
through the OUTPUT terminal. By connecting
a VCR to the OUTPUT terminal, you can
record the currently shown image and sound
to that VCR. To do this, connect the VCR and
OUTPUT terminal following the steps below.
1 Connect the VIDEO jack in the
OUTPUT terminal and the VCR's
VIDEO IN (video input) jack with
a video cable.
2 Connect the AUDIO jacks (L and
R) in the OUTPUT terminal and
the VCR's AUDIO IN (audio L/R
input) jacks with an audio cable.
• When you turn off the TV, the signals from
the OUTPUT terminal are also turned off.
• The component signals input from the
VIDEO-3/COMPONENT terminal cannot
be output through the OUTPUT terminal.

Connecting Headphones

Connect the headphons with a
stereo mini jack (of 3.5 mm in
diameter) to the Headphone jack
at the TV front panel.
Additional preparation
37