Table of Contents
Advertisement
Quick Links
Table of Contents
Introduction
Step 1. TV ...........................2
Step 2. STB...........................3
Step 3. Favorite Channel ........3
Step 4. Dual / Single Mode.......5
Step 5. Lock the remote...........5
Code Search..........................7
Learning................................7
Troubleshooting................................7
Code Retrieval..................................7
Resetting to Factory Settings...............7
Common codes:
TV:
Apex 2521
Dynex 0371
Insignia 0371
Magnavox 2321, 1151
Polaroid 2421
Panasonic 2711
RCA 2777
Philips 2321, 1151
Pioneer 0131
Samsung 0531
Seiki 0131
Sharp 2731
Toshiba 1121, 0231, 2861
Vizio 0001
Westinghouse 0531
STB:
Direct TV 0983
Verizon 0684, 0724
Flipper Instructions
A22v2.NA & EU
(North America & EU)
1
Advertisement
Table of Contents
Related Manuals for Flipper A22v2.NA & EU
Summary of Contents for Flipper A22v2.NA & EU
- Page 1 Flipper Instructions A22v2.NA & EU (North America & EU) Table of Contents Introduction Set up: Step 1. TV ………………………2 Step 2. STB…………………..3 Step 3. Favorite Channel ……..3 Step 4. Dual / Single Mode…….5 TV Only ON/OFF ...
- Page 2 Code Search and Learning. Step 1: TV Flipper is preset to many TVs with code 0001. To test, press and release TV – the light will flash once. Test the volume and on/off. If Flipper works your device, go to STB. If not, continue: Locate the 4-digit code for your TV in the TV code list.
- Page 3 4. Test On/Off and Volume. 5. If Flipper works the TV, then go to Step 2 to set STB. 6. If Flipper does not work the TV, try the next code. It may take several codes to find one that works.
- Page 4 “Enter” button: Some STBs may chance channels faster by using an “Enter” button. In Flipper, the STB Enter function is stored in Mute. (Flipper does not have “enter” for TVs). The only way to know if this is working for your device is trial and error.
- Page 5 To return to Dual on/off, press and hold ADD until the light turns solid, and enter 998. Step 5: Lock the Remote Control Locking Flipper deactivates the set up buttons to avoid reprogramming by accident. If you do not want to lock, set-up is complete.
- Page 6 Flipper Instructions A22v2.NA & EU (North America & EU) 1. Press and hold TV until the light turns solid, if searching for a TV code. (Use STB if searching for a STB code.) 2. Press and release On/Off. The light will flash, sending 10-15 codes to the TV. The light turns solid when the batch is done.
-
Page 7: Troubleshooting
IR signal. Flipper’s Learning IR bulb is the right side bulb. 1. Place both Flipper and your device remote on a table with the tops facing one another. 2. On Flipper, press and hold TV and On/OFF at the same time until the light starts to flash. Release the buttons.
Need help?
Do you have a question about the A22v2.NA & EU and is the answer not in the manual?
Questions and answers