JVC InteriArt Natural Vision T-V LINK AV-32WFR1EK Instructions Manual page 2

Thank you for buying this
To make sure your fully understand how to use your new TV, please read this manual thoroughly before you begin.




                                    



 




                  
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EX-
POSE THIS APPLIANCE TO RAIN OR MOISTURE.
                   
TO ENSURE PERSONAL SAFETY, OBSERVE THE FOL-
LOWING RULES REGARDING THE USE OF THIS UNIT.
1 Operate only from the power source specified (AC 220 –
240 V, 50 Hz) on the unit.
2 Avoid damaging the AC plug and power cord.
3 Avoid improper installation and never position the unit
where good ventilation is unattainable.
When installing this television, distance recommendations
must be maintained between the floor and wall, as well as
instalment in a tightly enclosed area or piece of furniture.
Please adhere to the minimum distance guidelines shown
for safe operation.
4 Do not allow objects or liquid into the cabinet openings.
5 In the event of a fault, unplug the unit and call a service
technician. Do not attempt to repair it yourself or remove
the rear cover.
6 For AV-32WFR1EK only:
The surface of the TV screen is coated with a thin film,
which can easily be damaged. Be very careful with it when
handling the TV.
Should the TV screen become soiled, wipe it with a soft dry
cloth. Never rub it forcefully. Never use any cleaner or de-
tergent on it.
7 When you don't use this TV set for a long period of time, be
sure to disconnect the power plug from the AC outlet.
8 Do not hold the front panel door when moving the TV, if you
do you may break it.


colour television.
10 cm 10 cm




                  
DO NOT cut off the mains plug from this equipment. If the
plug fitted is not suitable for the power points in your home or
the cable is too short to reach a power point, then obtain an
appropriate safety approved extension lead or adaptor or
consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock
hazard by inadvertent connection to the mains supply.
If a new mains plug has to be fitted, then follow the instruction
given below:
IMPORTANT
DO NOT make any connection to the larger terminal which is
marked with the letter E or by the safety earth symbol
coloured green or green-and-yellow.
The wires in the mains lead on this product are coloured in ac-
cordance with the following code:
Blue: Neutral
15 cm
Brown: Live
As these colours may not correspond with the coloured mark-
ing identifying the terminals in your plug proceed as follows:
15 cm
The wire which is coloured blue must be connected to the ter-
minal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
When replacing the fuse only a correctly rated approved type
should be used and be sure to re-fit the fuse cover.
IF IN DOUBT — CONSULT A
COMPETENT ELECTRICIAN.
How To Replace The Fuse
Open the fuse compartment
with a blade screwdriver, and
replace the fuse.
or
Fuse