Table of Contents
Advertisement
7. Use foam-safe CA to glue the plywood rudder
horn into position
Note: Ensure that the holes in the control horn
are in line with the hinge line.
Note: Do not use CA on the hinges until you
are sure the fit of the rudder is correct.
8. Test fit the rudder to the fuselage. Check that
when the hinge line of the rudder is against the
fuselage, the balance tab does not interfere with
the fin.
9. Once satisfied with the fit, apply 2–3 drops of
foam-safe CA to each side of each rudder hinge.
Work quickly to install the rudder before the CA
has time to cure.
21
Advertisement
Table of Contents
