Goldmund METIS User Manual page 8

4
CONNECTING THE BUILT-IN AMPLIFIER (Ctd.)
The Metis Speaker Wireless and the associated USB Goldmund dongle are delivered
prepaired from the factory. This means that your speakers can only function with the
dongle that was paired with it. However, if you would like to do a re-pairing of the speaker
with the dongle for any reason, please follow these steps:
- Connect the USB dongle to your computer or the Wireless Transmitter to your
acoustic processor.
- Insert a small screwdriver into the pairing hole located on the back panel of your
speaker, just above the input RCA.
- Gently press the internal pairing button using the screwdriver.
- As soon as the pairing is done, the led locking led will light up.
- The pairing is done.
In case you lose your dongle, you can order another one from your distributor who will also
pair it to your speakers.
The active crossover is carried out inside the Metis Speaker Wireless. There is one Telos
amplifier for the tweeter and one Telos amplifier for the woofer.
When used with a digital input signal, connect the digital cable to the digital input
connector. Since a digital Spdif cable carries 2 channels you may link the digital output to
the next speaker to transfer the second channel, this is also true with a wireless input
connection.
When the digital input does not receive any data for 3 seconds, the drivers are muted.
They are de-muted as soon as a signal is present on the digital input.
Mains power must not be deconnected while the Metis speakers Wireless are not muted
(please wait 3 seconds after the music stops before removing the mains power).
GOLDMUND METIS SPEAKER WIRELESS - 8