Parameter Table - Roland Super JX-10 Owner's Manual

PARAMETER TABLE

The Upper/Lower Tone Parameters can be reached and edited:
•
Typing the corresponding number with the numeric keypad 0 – 9
appears in the Display, push the VALUE of the Edit Buttons, then change the value with the α Dial
•
Pushing the PARAM button, rotate the a Dial, and the Factor shown in the Display will change in sequence.
When the Factor you wish to edit appears in the Display, push the VALUE of the Edit Buttons, then change the
value with the a Dial.
•
Assigning 2 selected Factors to C1 and C2 buttons:
Press PATCH button, press TONE button, press C1 or C2 button, then select the Factor with the α
o
Dial. In this way 2 different Factors can be controlled in real time with C1 or C2 buttons.
•
Directly and in a more straightforward way with a PG-800 (the current edited Factor will be temporarily shown if
MIDI - 42 EDIT DISPLAY is set on PG-800)
DCO (Digitally Controlled Oscillator)
DCO is the digitally controlled oscillator that controls the pitch and generates the waveforms that are the sound
source of the synthesizers. Owing to its digitally controlled system, this offers superior pitch stability compared with
the VCO (Voltage Controlled Oscillator). The JX-10 has 2 DCO's.
P a r a m e t e r
Display
Number
11 DCO 1 RANG
DCO-1 Range
21 DCO 2 RANG
DCO-2 Range
12 DCO 1 wf
DCO-1 Waveform
DCO 1 wf
22
DCO-2 Waveform
13 DCO 1 tune
DCO-1 Tune
DCO 2 tune
24
DCO-2 Tune
Data
Value
This is to change the pitch range of the DCO in exact
2'
one octave steps from 2' to 16' (2', 4',8', 16'). – 8' is
4'
standard.
8'
16'
This is to choose the output waveform of the DCO.
sawt
puls
squa
nois
This changes the frequency (pitch) of the DCO, in
+12
semitones steps.
0
Variable Range: ±12 (±1 Octave)
•
-12
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 22 of 53
When the Factor you wish to edit
F u n c t i o n Programmer