Guidelines On Using; (Ii) Cooling Water - Honda 1994 NSR 250 SP Setup Manual

1–2

1. GUIDELINES ON USING

2. Fuels
A machine installed with this kit is used after removing the standard oil pump. Fuels should be
mixed petrol.
Petrol: Avgas (equivalent to No3 petrol for common aeroplanes)
Specified mixing oil (proportion 30:1):
3. Cooling Water
A water cooled engine is installed on this machine.
Supply cooling water
Cooling water: Forcet or Bottled Water
i) Remove the radiator cap and pour cooling water up to the mouth.
ii) Hold handlebars and tilt the machine on either side two or three times to drain the air inside.
iii) Top up the radiator with cooling water if the level has become to low.
iv) Fit the cap tightly.
v) Check the level again after starting the engine.
[CAUTION]
•
When double-checking the level after starting the engine, cover the radiator with a cloth to
prevent the cooling water spurting.
•
Drain the cooling water in the catch tank before driving.
•
Drain the cooling water after running to prevent possible troubles such as decay or blockage in
the radiator or the engine's coolant passages.
•
Cooling water may freeze in wintertime. Coolant can be added, however, special cautions are
required to avoid a danger in case of leakage on a racecourse.
Elf HTX 975 (part no. 88881-NF4-610)
Elf HTX 976 (part no. 88881-NF4-900)
Castrol A747 (part no. 88882-ND4-000)