1-9
5. SEALING PLUG SET
1. Kick starter
•
As the kick start is not used during racing, remove the spindle shaft, then press the sealing plug
∅ 28 in where the shaft has stayed.
Sealing plug ∅ 28:
2. Oil pump
•
The oil pump is not used for a machine installed with the kit as mixed petrol (petroil) is used,
therefore, remove it and press the sealing plug ∅ 20 in.
Sealing plug ∅ 20:
•
Apply adhesive to the cone plug 4.5 x 8, then press it in the crank case.
Cone plug 4.5x8:
90807-NKD-940
3. Oil filler cap
•
Make a hole on the standard oil filler cap for wiring (∅ 2) with a drill or exchange it for the kit.
Oil filler cap:
15611-NH3-000
4. Oil drain bolt
•
Make a hole on the standard drain bolt for wiring (∅ 2) with a drill or exchange it for the kit.
Oil drain
bolt:90081-NF5-000
90871-733-003
91201-NH3-003