1. Manuals
  2. Brands
  3. Myryad Manuals
  4. DVD Player
  5. MXV4000
  6. Owner's manual

Myryad MXV4000 Owner's Manual

Remote controlled dvd / sacd player
Hide thumbs
Table of Contents

Advertisement

Quick Links

MXV4000
Remote Controlled
DVD / SACD Player
Owner's Manual
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MXV4000 and is the answer not in the manual?

Questions and answers

Related Manuals for Myryad MXV4000

Summary of Contents for Myryad MXV4000

  • Page 1 MXV4000 Remote Controlled DVD / SACD Player Owner’s Manual...

  • Page 2: Table Of Contents

    DVD-Video, VCD, SVCD, DVD-R/-RW, DVD+R/+RW, other Myryad products that can then be remote- CD, CD-R, CD-RW, HDCD, MP3, WMA, SACD multi- controlled via the MXV4000 's infra-red receiver - or channel, SACD stereo, JPEG (picture CD), JPEG with vice-versa. MP3, Xvid and DivX.

  • Page 3: Installation And Safety

    DVD REGION CODE INSTALLATION AND SAFETY DVD discs and players are manufactured under the This DVD player generates very little heat but still worldwide agreed DVD Regional Code System. This requires some ventilation. Do not place it on a rug or player will operate only with a corresponding disc of the other soft surface into which it could sink, obstructing the same Region Code as that marked on the rear panel...

  • Page 4: Setting Up Your System

    It is recommended that the POWER switch is turned connector you should skip to “Component video” below. OFF if the MXV4000 is not going to be used for an Note: If connecting to a DVI input, it must support extended period of time.

  • Page 5: Audio Outputs

    MXD4000 processor for example). then you do not need to use these jacks. It is a special feature of the MXV4000 that both the Stereo and Multi-channel analogue outputs use high quality DACs and identical audio circuitry, so the sound quality will be the same across all the audio outputs.

  • Page 6: Control Inputs/Outputs Etc

    The My-Link bus allows any linked product to be remote- controlled via the MXV4000’s infra-red receiver - or vice- versa. The MXV4000 (or any other product on the My-Link bus) can be controlled from a remote room via a suitable interface to the My-Link bus.

  • Page 7: Operating Your System

    "standby" mode and the LED (Light Emitting Diode) in discs, or small 80mm discs. the display will glow red. In this mode most of the internal circuitry of the MXV4000 is switched off so that it consumes very little power. Only the IR receiver, My- 5. OPEN/CLOSE Link and RS232 interface function in standby.

  • Page 8: System Operation With Smart My-Link

    Smart My-Link® equipped Preamplifier Processor, PLAY/PAUSE or PLAY is pressed in Resume Stop Stereo Preamp or Integrated Amplifier) Myryad products mode the disc will start playing from the same point at equipped with Smart My-Link® have a number of extra which STOP was pressed.

  • Page 9: Remote Control Operation

    MSR2 System Remote – DVD/Amplifier mode for MXV4000 Important: To control the MXV4000 first press the “DVD” key to switch the remote to “DVD/Amplifier” mode. It will remain in this mode until either the TUN or CD key is pressed to change to Tuner/Amp or CD Amp mode. When in “DVD/Amplifier”...

  • Page 10: Essential Setup

    For system setup a TV or monitor must be connected to of the screen, or press the Setup key at any time within a one of the MXV4000’s video outputs. A composite video menu, to exit the Setup menu system and return to (CVBS) or s-video connection is recommended for initial normal operation.
  • Page 11 TV. The MXV4000 will process video receiver or processor can accept 96kHz PCM inputs. signals from NTSC discs and output them in PAL Otherwise set to 48kHz and the MXV4000 will down- format. sample to 48kHz when necessary.

  • Page 12: Playing A Dvd

    Make sure that the regional code number on your disc (if present) is the same as the regional code number on the Slow Play Forward/Reverse printed label on the rear panel of the MXV4000. If a disc When in play mode press the cursor down key to play with the wrong regional code is inserted the VF display forward in slow motion at half speed.
  • Page 13 2.10 MENU Press MENU to access the DVD’s menu (usually the Note: The Sound Mode setting does not affect the “root” menu) if it is available. digital audio outputs. 2.11 TITLE 2.13 ZOOM Press TITLE to access the DVD’s “Title” menu (only Press the ZOOM key to magnify the size of the TV applies to certain multi-title discs).
  • Page 14 The navigation keys and SEL may be used to 2.18 ON SCREEN DISPLAY (“TIME” key on select any of these parameters and edit them. For remote) instance, if the “TIME DISP” is edited then the VF When the TIME key is pressed the TV picture will be display’s time display will also change through TITLE reduced in size and the bottom half of the TV screen will ELAPSED, TITLE REMAIN, CHAPTER ELAPSED and...

  • Page 15: Playing A Cd

    3. PLAYING A CD 4. PLAYING AN SACD In most respects playing a CD is exactly the same as The SACD (Super Audio CD) standard is based on DSD playing a DVD. This section therefore just describes the (Direct Stream Digital) technology. The DSD format is a main differences in operation.

  • Page 16: Playing An Mp3/Wma/ Divx/Xvid/Jpeg (Picture Cd)

    Playing MP3 music and JPEG pictures simultaneously 5. PLAYING AN MP3/WMA/ When a disc that contains both music and picture data is DivX/XviD/JPEG (PICTURE CD) loaded the disc menu will appear on the TV screen. Select an MP3 track and, when the MP3 music track is When the disc is loaded reading time may exceed 30 playing, select a picture from the TV screen and press seconds depending upon the complexity of the...

  • Page 17: Setup Menus

    PROGRAM Highlight “DIVX(R) VOD CODE” and then press SEL. The MXV4000 can be programmed to play some or all of The registration code will appear. Press SEL again to the contents of a disc in any desired order. Up to 20 exit.

  • Page 18: Audio Setup Page

    48 or 96kHz. This only affects certain discs which have 24bit 96kHz soundtracks. Only set to 96kHz if your receiver or processor can accept 96kHz PCM inputs. Otherwise set to 48kHz and the MXV4000 will down- sample to 48kHz when necessary. The default setting is 48kHz SPEAKER SETUP (5.1 ch analogue outputs only)

  • Page 19: Video Setup Page

    Setting upsampling to OFF returns the data rate to the Select this if the connected TV is a “PAL CD standard of 44.1kHz. The default setting is system only” TV. The MXV4000 will process UPSAMPLING OFF. video signals from NTSC discs and output...
  • Page 20 Enables you to adjust the HDMI output PICTURE SETTING resolution to 480p, 576p, 720p, 1080i or AUTO to suit The MXV4000 has three predefined picture settings and the monitor you are using. one personal setting that you can define yourself. This...

  • Page 21: Preference Setup Page

    TRUE LIFE (HDMI only): TrueLife™ Enhancement Notes: identifies details in an image and enhances them to – VCD, SVCD, CD, SACD have no level indication, so make them more visible and more lifelike. The the parental control function has no effect with these technology also enhances large edges to create greater types of discs.

  • Page 22: Use Of Mx-700 Remote (As Supplied With Mxd4000/7000 Etc.)

    Owner’s Manuals. Most of the DVD page commands on these MX-700s will work correctly with the MXV4000, but there are a few small differences between the MXV4000’s remote commands and those for previous Myryad DVD players, so some of the commands will have different functions when controlling the MXV4000.

  • Page 23: Trouble-Shooting

    TROUBLE-SHOOTING Symptom Suggested Action Check that power cord is properly connected to power outlet • No Power Check that power is switched on at socket and on rear panel • Disc is loaded upside down. Place the disc with label side up. •...

  • Page 24: Appendix 1

    Many earlier model TVs with DVI inputs will not operate with the • I am using an HDMI-to-DVI adapter MXV4000’s HDMI output because they are not HDCP-compliant (digital and the image is scrambled or is not copyright protection). Check your TV’s owner’s manual or contact your visible at all.
  • Page 25 Inupiaq 7375 Pali 8073 Irish 7165 Panjabi 8065 Italian 7384 Persian 7065 Japanese 7465 Polish 8076 Javanese 7486 Portuguese 8084 Kalaallisut 7576 Provençal; Occitan (post 1500) 7967 Kannada 7578 Pushto 8083 Kashmiri 7583 Quechua 8185 Kazakh 7575 Raeto-Romance 8277 Khmer 7577 Romanian 8279...

  • Page 26: Appendix 2 Glossary

    Y, Pb and Pr (or sometimes Y/Cb/Cr or Progressive Scan: Displays all the horizontal lines of a Y/U/V). picture at one time, as a signal frame. The MXV4000 Disc menu: A screen display prepared for allowing can convert the interlaced video from DVD into selection of images, sounds, subtitles, multi-angles, etc.

  • Page 27: Specifications

    SPECIFICATIONS Disc formats supported DVD-Video, VCD, SVCD, DVD-R/RW, DVD+R/RW, DivX, Xvid, SACD multi-channel, SACD stereo, CD, HDCD, MP3, WMA, CD-R, CD-RW, JPEG (picture CD), JPEG with Programming Capacity 20 tracks Audio Formats Digital Dolby Digital/DTS/MPEG Compressed Digital 16, 20, 24 bits fs 44.1, 48, 96 kHz MP3 (ISO 9660) 64 –...
  • Page 28 Web: www.myryad.co.uk Myryad is part of Armour Home Electronics Units 7&8 Stortford Hall Industrial Park Dunmow Road Bishops Stortford Hertfordshire CM23 5GZ United Kingdom Tel: +44 (0) 1279 501111 Fax: +44 (0) 1279 501080 Web: www.armourhe.co.uk Revision: page 28 of 28...

Table of Contents