The Wireless Learning Code; Wireless Detector And Device Learning Code; Remote Control And Device Learning Code; Faq And Maintenance - NPC Network Phone Camera User Manual

6.1 Wireless detector learn code to match the NPC
In order to trigger the alarm, all the wireless detectors must learn code to match the NPC. The
specific operation as follows: First press device learning button, when the red lamp of two-color
LED lights up, then trigger the wireless detector that need to be matched to transmit a signal, if the
red lamp of two-color LED flashes which indicates learning is success, after the learning succeed,
when the wireless detector is triggered then the red lamp of two-color LED will be lighted up.
Analogously, the device can learn 4 different-code wireless detectors.
6.2 Remote controller learn code to match the NPC
In order to control the device normally and make or cancel the defense, all the remote controller
must learn code to match the NPC. The specific operation as follows: First quickly press device
learning button twice, when the Yellow lamp of two-color LED lights up, then press any buttons of
remote controller to transmit a signal, if the Yellow lamp of two-color LED flashes which indicates
learning is success, after the learning succeed, when press any buttons of remote controller then the
Yellow lamp of two-color LED will be lighted up. Analogously, the NPC can learn 4 different-code
remote controllers.
7.1 FAQ
If the problems are not listed, please contact local service or call the HQ service, we will try the
best to serve you.
The NPC cannot boot up normally.
Possible reasons are as follows:
1.The power supply is wrong.
2.Switch power supply line is not in good connection.
3.Switch power supply is damaged.
4.The program updating is wrong.
5.The front panel is damaged.
The NPC reboots automatically or stops working after boot up a few minutes
Possible reasons are as follows:
6 Wireless learning code

7 FAQ and maintenance

22
Network Phone Camera User Manual