Table of Contents
Advertisement
DIGITALS INPUTS
The GSM has the ability to send a SMS text message to alert if it is being used. Each
input can be configured independently with the following parameters. Inside the
GSM, IN1 and IN2 will be the associated relays for the alarm:
• Contact type: Set if the contact is normally open or normally closed
• On time: Time the input has to be activated to produce trigger the alarm
• Off time: Time the input has to be deactivated to stop producing the alarm
• Restore Time: Time since an alarm has stopped until a new alarm can be produced
Alarms produce SMS texts for all registered users. The SMS text message can be
customized for each relay. The alarms will be logged into the GSM's history and can
be reported through GSMTool.
USER MANAGEMENT
The first user added to the GSM is the device master, which can be changed by a
SMS text or through GSMTool. The system supports any number of administrator
users. Users can be added via a call while pressing the PROG button, via SMS, or via
GSMTool.
Each user will be added with the following information:
• Phone number: the system supports up to 15 digits with international prefix (ITU-T
E.164 recommended)
• Access relay: Relay that will be used in two channel and automatic cycle modes.
• Timetable: Hour interval in which the system will grant access to the user. It can be
unlimited
• Use limit: Number of accesses the system will grant to the user. It can be unlimited
• Administrator: Establishes whether the user is an administrator or a normal user
• Enabled: Establishes whether the user is enabled in the device or not
• Inputs: Alarm input subscription for the user
Administrator users can use most of the configuration SMS and can, therefore,
manage the device.
ACCESS EVENTS
The GSM has can memorize up to 8000 events. Those events can only be read using
the GSMTool application via USB. For the event system to work, the device needs to
be configured with the correct date and time and have a button battery installed to
keep the clock going when the main power is unavailable. The battery must be
installed with the device powered on.
SMS GUIDE
Configuring your GSM through SMS texting is available to only the administrators
and the master user. SMS TEXTING IS CASE SENSITIVE. All parameters separated
by commas can be omitted to select its default values. Leaving no information
between commas also will select its default values.
Ex:
#0000#NEWU+3495789056#B,2@ -> not written parameters will take their default
values
#0000#NEWU+3495789056#B,2,,,0,23@ -> UM and Uses will take their default values
Advertisement
Table of Contents
