Install Batteries In Wireless Devices; Link All Devices To Wireless Network - Honeywell RedLINK Installation Manual

2

Install batteries in wireless devices

When system wiring is complete, install batteries in all devices. Make sure
batteries are inserted properly (see polarity marks on illustrations below).
Thermostat
Remote control (optional)
M28475
3

Link all devices to wireless network

Press and release CONNECT
Flashing status light times out after 15
minutes of inactivity. Press
again if necessary.
Français : voir la page 21 • Español: vea la página 41
M28472
Install 2 fresh AA
batteries
Install 3 fresh AA
batteries
M28495
CONNECT
M28473
Outdoor air sensor (optional)
Restore AC power, then press and release
the CONNECT button at the EIM. Wait for
green flashing light to begin linking devic-
es to the wireless network (see pages 6-7).
If the light stops flashing before you have
linked all devices, press CONNECT again.
If light does not flash, another EIM/
wireless adapter may be in wireless setup
mode. Exit wireless setup at the other
EIM/wireless adapter.
5
Programmable models only
Install quick reference
card
Install 2 fresh AA
lithium batteries
M28476
Continued on next page
69-2091EFS—07
M28474
>>