COMP CT DISC RECEIVER
8. PRE MP OUTPUT CONNECTOR
The line out signal of this unit can be used for connecting to another amplifier, e.g. recorder or signal
processor etc.
9. SPE KER TERMIN L
These terminals are for the connection to speakers. Select the 4
Do not select both low and high impedance terminals else overload may occur.
Voltage/Impedance
100V
70V
25V
4
10. IMPED NCE SELECTOR
This switch is for selecting the required high impedance at the speaker terminals.
* W RNING: For low impedance output (4 ), remove the jumper from the option terminals. For high
impedance output (70V, 100V) install the jumper. Do not use both the low and high
impedance outputs at the same time, doing so could damage your amplifier and invalidate the
warranty.
8
CR-120M
MODEL
terminals or the high impedance terminals.
CR-120M
83
41
5.2
4 / 21.9V