Compaq ELSA GLoria Synergy Installation Manual page 15

5. From the Display Properties dialog box, choose the Settings tab.
6. From the Settings dialog box, choose the Display Type button to see the driver and
adapter (board) information.
7. From the Display Type dialog box, choose Change.
8. From the Change Display dialog box, choose Have Disk.
9. In the Install from Disk dialog box, you are prompted to insert the manufacturer's
installation disk into the selected drive. Insert the appropriate diskette (Alpha or Intel)
into the floppy drive (or the Graphics Support Services Software CD-ROM that will be
included in future releases into the CD-ROM drive unit).
10. Enter the path of the PowerStorm 4D10T driver and choose OK.
The path is of the following format, where
for floppy diskettes or
dev:\
dev:\i386\pbxgk\nt40
or
dev:\alpha\pbxgk\nt40
11. In the Change Display dialog box, the driver whose path you just defined is displayed.
Confirm this choice by choosing OK. The driver name displayed is:
PowerStorm 4D10T
12. When the message displays stating that this is a third party driver, confirm by choosing
Yes. A status box displays reflecting the progress of the driver installation.
13. When the files have been copied to your hard disk, a dialog box indicating that the
driver was successfully installed is displayed. Choose OK and remove the CD-ROM
from the drive.
14. Choose Close to close the Display Type dialog box.
15. Choose Close to close the Display application.
16. When a message displays stating that you must restart your computer to use the new
display driver, choose No.
17. Shut down your system by choosing Shut Down from the Start menu, then remove
power from your computer system and install the PowerStorm 4D10T graphics option
as described in Section 2.4 if you haven't already done so.
dev:\
for the E drive):
E:\
(Alpha or Intel systems - Floppy Diskettes)
(Intel systems - GSSS CD-ROM)
(Alpha workstations - GSSS CD-ROM)
is the drive name (for example,
Installation
A:\
2-3