Table of Contents
Advertisement
Quick Links
© 2009 Edge Lighting. All Rights Reserved.
Installation Instructions for
IMPORTANT INFORMATION
- This product is ETL listed for indoor location.
- This product is wall mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
Install the Fixture
A
1
HEAD
1.5MM ALLEN
WRENCH
M3 SET SCREW
1
SWIVEL
CONNECTOR
HEAD
2: Insert the loose arm assembly (provided in the box) into the
other swivel connector, insert the joining arm into the
mounting bracket of the first arm. Tighten the M3 set screw
on the swivel connector
1.5mm Allen wrench.
Cody 12" Canopy Mount Picture Light
ARM
ARM
and mounting bracket
with the
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
1: Rotate the Cody's head perpendicular to the arm making
sure the arm is completely inserted into the head swivel
connector. Tighten the M3 set screw on the swivel connector
with the provided 1.5mm Allen wrench to secure the head in
place.
B
MOUNTING BRACKET
2
CPL-12-_
JOINING ARM
2
HEAD
ARM
1.5MM ALLEN
WRENCH
M3 SET SCREW
SWIVEL
CONNECTOR
904-CPL-12-01
1
Advertisement
Table of Contents
Related Manuals for Edge Lighting Cody 12"
Summary of Contents for Edge Lighting Cody 12"
- Page 1 Chicago, IL 60614 Tel: 773-770-1195 Fax: 773-935-5613 www.edgelighting.com info@edgelighting.com © 2009 Edge Lighting. All Rights Reserved. Cody 12" Canopy Mount Picture Light Installation Instructions for IMPORTANT INFORMATION - This product is ETL listed for indoor location. - This product is wall mounted only.
- Page 2 MOUNTING BRACKET NOTE: The Cody 12" canopy mount must be installed right above the electrical box. 3: Hold the two mounting brackets against the wall above the electrical box. Using a level, align the mounting brackets and mark the four bracket holes on the wall. 4: Tap the anchors onto the marked points into the wall up to the threaded portion with a hammer.
- Page 3 13: Place the excess wires and wire nuts inside the electrical box. 14: Line up the canopy cut out edge with the fixture wires. Place the canopy onto the electrical box and tighten the thumb nut to the crossbar assembly nipple.
Need help?
Do you have a question about the Cody 12" and is the answer not in the manual?
Questions and answers