Connecting The Aerial And Vcr - JVC 0803-NIC-JMT Instruction Manual

Preparation

3 Connecting the aerial and VCR

• Read the manuals provided with the devices. Depending on the device, the connection
method may be different from the diagrams. Also the device settings may need to change
depending on the connection method.
• Turn off all the devices including the TV.
• Connecting cables are not supplied.
• When connecting monaural audio to the TV, use the L/MONO jack.
• The AV-21Y311 and AV-16N311 are supplied with rod aerial but without matching aerial
adapters.
• You can connect an S-VIDEO compatible device (such as an S-VHS VCR) to the S-connector
with an S-VIDEO cable and enjoy the high quality picture of the S-VIDEO signal (Y/C
signal). In that case, do not connect it to the TV with a video cable.
• If you connect the VCR to the TV only with an aerial cable, you should preset the video
channel from the VCR to the AV channel (channel number 0) on this TV. See "MANUAL CH
PRESET" on page 16 and preset it manually.
Connecting the aerial
To install rod aerial:
Install into the top-rear aerial holder. Once installed, it cannot be removed.
VHF/UHF outdoor aerial
Connecting the aerial and VCR
4
Matching
aerial
adapter
(supplied)
COMPONENT
VIDEO-1
(VIDEO-2)
INPUT
INPUT
S
OVER
V Y
/ V
L C L
B
/ /
MONO MONO
R C R
R
3
To video To audio
output output
To S-video
output
VCR
To aerial input
Indoor aerial
Rod aerial
OUTPUT
V
L
R
• Illustration of AV-21Y311
COMPONENT
VIDEO-1
( VIDEO-2 )
OUTPUT
INPUT
INPUT
S
OVER
V Y V
/
V
L C L L
B
/ /
MONO MONO
R C R R
R
To RF
output
1
(1)
(2)
(3)
VHF/UHF outdoor aerial
2