JVC TM-1051DG Instructions Manual page 5

5 UNDER SCAN button
Reduces the screen size so that the whole screen is
displayed.
6 SCREENS CHECK button
Only the selected luminance signal or RGB element
of a video signal is displayed. Each time you press
this button, the screen changes in the following
order:
Normal screen = Monochrome screen =
Red screen = Green screen = Blue screen =
(back to the beginning)
7 MARKER button
Turns the MARKER function ON/OFF.
• MARKER function includes MARKER SELECT,
ASPECT SELECT, and SAFETY MARKER
functions.
☞ "MARKER" on page 12
NOTES:
• Functions do not operate when they are set to "OFF" in
the "MARKER" menu.
• Initial setting of each function in the "MARKER" menu is
"OFF." Before you use the MARKER function, you must
change the "MARKER" menu settings first.
8 INPUT SELECT buttons/lamps
Select an input to display.
A: Select the video signal input to the VIDEO A
terminal.
B: Select the video signal input to the VIDEO B
terminal.
C: Select the signal input to the E. AUDIO SDI IN
C terminal.
D: Select the signal input to the E. AUDIO SDI IN
D terminal.
• The corresponding lamp of the input currently
selected lights up.
9 Power lamp
Unlit: The main power is off.
Orange: The main power is on and the monitor is in
stand-by mode.
Green: The monitor is on.
p Stand-by button
Turns on and off the monitor when the main power
is on.
NOTES:
• Turn on the main power by using the main power switch
on the rear panel.
• You can set the delay time between when the stand-by
button is pressed and when the monitor actually turns on.
☞ "RUSH DELAY TIME" on page 14
7 About the status display
Displays information of the current input selection
and the monitor settings for about 3 seconds.
To show the status display, set "STATUS DISPLAY"
to "AUTO" or "MANUAL" beforehand.
☞ "STATUS DISPLAY" on page 16
Pressing the INPUT SELECT button currently
selected shows the status display.
NOTE:
• When "STATUS DISPLAY" is set to "AUTO," the status
display also appears on the screen if you change the
inputs or the signal condition changes.
1 Input status
2 Signal format
• "NO SYNC" is displayed when no video signal
is input or no synchronized signal is detected.
• If "NO SYNC" is displayed even though a video
signal is input, check the setting of "SYNC
SELECT."
☞ "SYNC SELECT" on page 14
• "Out of range" is displayed when a
noncompliant signal is input.
3 Setting of "COLOR TEMP."
☞ "COLOR TEMP." on page 15
" * " is displayed if white balance is adjusted in the
"COLOR TEMP./BAL." menu.
4 Appears when "SYNC SELECT" is set to
"EXT." (External synchronization)
☞ "SYNC SELECT" on page 14
5 Setting of UNDER SCAN
☞ "5 UNDER SCAN button" on the left column
OVER: Over-scan
UNDER: Under-scan
6 Setting of SCREENS CHECK
☞ "6 SCREENS CHECK button" on the left column
COLOR: Normal screen
MONO: Monochrome screen
R ONLY: Red screen
G ONLY: Green screen
B ONLY: Blue screen
7 Setting of MARKER
☞ "7 MARKER button" on the left column
5