Changing Remote Control Batteries - Emotiva ERC-3 GEN 2 User Manual

Changing Remote Control Batteries

Emotiva recommends using high quality Alkaline AAA batteries in the ERC-3 remote control.
Removing the Battery Protective Strip
When you receive your ERC-3, the batteries in the remote control will be disabled by a small
plastic strip placed between the battery and the battery contact to prevent them from becoming
drained during shipping and storage. This strip must be removed to activate your remote control
before using it.
• Carefully remove the six phillips head screws securing the back of the remote control.
Note: Be sure to use the correct size screwdriver to avoid stripping or damaging the screws.
• Locate the battery holder.
• Carefully pull out the plastic strip inserted between the end of one of the batteries and the
metal contact strip in the battery holder.
• Carefully replace the six phillips head screws securing the back of the remote control.
Your remote control is now ready to use.
Replacing the Remote Control Batteries
• Carefully remove the six phillips head screws securing the back of the remote control.
• Locate the battery holder.
• Note the direction in which the batteries are installed in the holder.
• Remove the depleted batteries and dispose of them in accordance with the manufacturer's
recommendations.
• Insert new batteries, taking care to insert them in the same orientation (facing the same way)
as the original batteries.
• Carefully replace the six phillips head screws securing the back of the remote control.
Your remote control is now ready to use.
ERC-3
Page 16