Honda 1994 Civic Owner's Manual page 151

Main Menu
Lights
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end
into the slot.
6. Push the rubber weather seal
over the bulb.
7. Push the electrical connector
onto the tabs of the new bulb.
Turn on the headlights to test
the new bulb.
8. (Passenger's side)
Reinstall the air intake tube.
Maintenance
Table of Contents
Replacing an Auxiliary Light
Bulb
The auxiliary lights are located
next to the headlights.
1. Open the hood.
2. Remove the socket by turning it
one-quarter turn counterclock-
wise.
3. Remove the burned-out bulb
from its socket. To remove the
bulb, push it in slightly and turn
it counterclockwise.
4. Insert the new bulb in the socket.
Reinstall the socket.
5. Test the bulb by turning on the
headlights (low beam) and
auxiliary lights.