Table of Contents
Advertisement
Item
Effect
Contrast
Less
Brightness
Darker
Colour
Less
Tint
(NTSC only)
Reddish
Sharpness
Less
Note:
In PICTURE, there is not a noticeable change even when contrast is increased with a bright picture or reduced with a
dark picture.
Advanced settings
Item
Effect
Black
extension
Less
Input level
Less
W / B High R
Less
W / B High B
Less
W / B Low R
Less
W / B Low B
Less
Gamma
Down
AGC
Off
Notes:
(1) Carry out "W / B" adjustment as follows.
A Adjust the white balance of the bright sections using the "W / B High R" and "W / B High B" settings.
B Adjust the white balance of the dark sections using the "W / B Low R" and "W / B Low B" settings.
C Repeat steps A and B to adjust.
Steps A and B affect each other's settings, so repeat each step in turn to make the adjustment.
(2) The adjustment values are memorized separately for each input mode (INPUT1, INPUT2, INPUT3 and PC IN).
(3) The adjustment range values should be used as an adjustment reference.
Helpful Hint (
On the remote control unit, while the "Advanced settings" menu is displayed, if either the N button is pressed at any
time or the
(ACTION button) is pressed during "Normalise", then all adjustment values are returned to the factory settings.
Adjustments
Selects the proper brightness and
density for the room.
More
Adjusts for easier viewing of dark pictures
such as night scenes and black hair.
Brighter
Adjusts colour saturation.
More
Adjust for nice skin colour.
Greenish
Adjusts picture sharpness.
More
Adjusts the dark shades of the image in gradation.
(This cannot be adjusted when the input signal is RGB or PC.)
More
Adjustment of parts which are extremely bright and hard to see.
More
Adjusts the white balance for light red areas.
More
Adjusts the white balance for light blue areas.
More
Adjusts the white balance for dark red areas.
More
Adjusts the white balance for dark blue areas.
More
S Curve
Up
Increases the brightness of dark signal automatically.
On
N
/
Normalise
Picture Adjustments
Notes:
(1) "Colour" and "Tint" settings cannot
(2) You can change the level of each
(3) The setting details for normal,
(4) The "Tint" setting can be adjusted
Details
2.0
2.2
Normalisation)
be adjusted for "RGB" and "PC"
input signals.
function (Contrast, Brightness,
Colour, Tint, Sharpness) for each
Picture menu.
dynamic and cinema respectively
are memorized separately for each
input mode (INPUT1, INPUT2,
INPUT3 and PC IN).
for NTSC signal only during "AV
(S Video)" input signal.
2.5
19
Advertisement
Table of Contents
