Setting The Receivable Signal Types - JVC GD-V4210PCE Instructions Manual

Video Adjustments
5 / 5
2 / 3
DISPLAY
VIDEO A
MUTING
MULTIPLE
MODE
MENU/EXIT
MENU/EXIT
RM-C575 REMOTE CONTROL UNIT
22
(Continued)
MENU INPUT POWER
MENU INPUT POWER
MENU
ASPECT POWER
VIDEO B COMPO.
RGB
VOLUME
MONITOR ADJUSTMENT
ID SET ID
2 / 3
5 /

Setting the Receivable Signal Types

You can set the receivable signal types. Normally, select
"AUTO."
A common setting will apply to both VIDEO A and B
terminals, and a different setting will apply to the
COMPONENT terminals.
1
Press MENU/EXIT (or MENU on the
Monitor) to display the Main Menu.
Cursor (3)
E N T E R :
2
Press 5/∞ to move the cursor (3) to
"FUNCTION SELECT."
3
Press 3 to display the Function
Selection Menu.
A D J U S T :
* "PICTURE MODE" and "SIGNAL MODE" do not
appear at the same time.
"PICTURE MODE" appears when RGB input is
selected, and one of the following signals comes in —
RGB15K-50, RGB15K-60, PC98, VGA480-60, SVGA-56,
SVGA-60, and XGA-60. On the other hand, "SIGNAL
MODE" appears when VIDEO A, VIDEO B, or COMP.
(component) input is selected.
4
Press 5/∞ to move the cursor (3) to
"SIGNAL MODE."
5
5
Press 2/3 to select the receivable video
signal type.
Each time you press the button, the receivable video
signal type changes as follows:
• When VIDEO A or VIDEO B input is selected:
AUTO
SECAM
• When COMPONENT input is selected:
AUTO
1080i
(1035i)*
* Changes according to the "HD SIGNAL MODE"
setting (see page 27).
6
Press MENU/EXIT (or MENU on the
Monitor) twice to exit the menu
operations.
M A I N M E N U
P I C T U R E A D J .
S I Z E / P O S I T I O N A D J .
F U N C T I O N S E L E C T
S T A T U S D I S P L A Y
S E L E C T : E X I T : M E N U
F U N C T I O N S E L E C T
C O L O R T E M P . : H I G H
*
P I C T U R E M O D E : S T I L L
A S P E C T : P A N O R A M A
S I G N A L M O D E : A U T O
: A
R G B I N P U T
r e s e t
S E L E C T : E X I T : M E N U
NTSC NTSC4.43
PAL
480i 576i
720p 480p
*