Table of Contents
Advertisement
set up and operating Instructions
Read the entIRe IMpoRtant
saFetY InFoRMatIon
section at the beginning of
this manual including all text
under subheadings therein
before set up or use of
this product.
Installing Remote
Control Batteries
Before first use and when the
Remote Control batteries need to be
changed, install 2 "AA" batteries:
1.
Slide open the battery cover on the
bottom of the Remote Control.
2.
Insert two "AA" batteries (sold
separately), being careful to position
the batteries in the proper polarity.
3.
Replace the battery cover.
Charging the Car Batteries
1.
Place the Battery Pack on a dry
fireproof surface in a room where
the temperature is from 50‑104º F.
note: If recharging a newly spent Battery
Pack, allow it to cool completely before
charging. Check that the Battery
Pack is undamaged; do not charge
a cracked or leaking battery pack.
2.
Plug the charger into a grounded,
120 V~, 60 Hz outlet.
3.
Plug the Battery Pack into the Charger.
4.
Allow the Battery Pack to
charge for 4 to 5 hours.
Page 4
For technical questions, please call 1‑800‑444‑3353.
5.
When the Battery Pack is done
charging, unplug it from the Charger
and unplug the Charger from the outlet.
6.
Allow the Battery Pack to cool
completely before using it.
7.
Store the Charger indoors,
out of reach of children.
WaRnIng! DO NOT use a different
Charger or Battery to power
this Remote Control Car.
Installing the Car Batteries
1.
Locate the Power Switch on the
bottom of the Car and turn it off.
2.
Remove the four clips on the top of
the body and remove the body.
3.
Unthread the screw holding the Battery
Cover and remove the Battery Cover.
SKU 68770
Advertisement
Table of Contents
