Troubleshooting - Intelligent USB-DMX interface Hardware Manual

Hardware
SYMPTOMS
Software cannot found USB
interface
DMX fixture does not respond
X Troubleshooting
CAUSES
USB cable is not connected properly
or USB port is faulty "Intelligent USB
DMX Interface" is not mentioned in
list of devices : driver is not installed
Interface is off Yellow leds are
switched on but red led does not
flash
Receivers do not detect DMX, yet
DMX signal output is operational
DMX red led flashes, but DMX
signal output is not operational
X Troubleshooting
REMEDIES
Check cable connection
or use another USB port
See section "How to
install USB-DMX 512
interface" Select "USB"
position on power supply
or connect via an
external power supply
Switch box breakdown :
contact your retailer
Check DMX wire and if
possible test another
DMX receiver Replace
the 8 pin-chip set in the
interface box.
Page 15