Sealed Surface Burners; Conventional Burners - Maytag RV Use And Care Manual

Rv cooking appliance
Table of Contents

Advertisement

SEALED SURFACE BURNERS,

select models
The porcelain on the burner is durable but over time and with
use may gradually lose its shine.
The three sealed surface burners are secured to the cooktop
and are NOT designed to be removed by the consumer.
Select models feature one special POWER BOOST sealed
burner located at the front. Use this burner to quickly bring
water to a boil.
Clean burner cap after each use especially if a spillover
occurs. A soiled burner may result in improper ignition or an
uneven flame. When cleaning the sealed surface burner,
use care to prevent damage to the ignitor. If a cleaning cloth
should catch the ignitor, it could be damaged or broken.
If burner does not light:
1. The surface burner will not light if the ignitor is damaged,
broken, soiled or wet. The burner will also not light if the
ports, especially the small port located directly below the
ignitor, are blocked.
2. Check to see if the burner ports are clogged. If so, clean
with a straight pin or small metal paper clip.
SEALED BURNER HEAD
MAINTENANCE
Lip
Ports
Ignitor
Port directly below ignitor
CONVENTIONAL SURFACE BURNERS,
select models
Your RV range or cooktop will feature three surface burners.
Each burner is secured in place with a screw. When burner is
cool, remove the screw before removing the burner. When
re-installing the surface burner be sure to replace the screw.
If the surface burner does not light, check to see if the burner
ports are clogged. If so, clean with a straight pin or small
metal paper clip. Be sure the standing pilot is lit. Check to be
sure that the burner is correctly installed.
To install surface burner: The air shutter end on the burner
should fit over the orifice hood.
To install surface burner with Piezo ignition: The two
tabs on each flashtube should be securely inserted into the
two slots on each burner head.
Slots
The flashtube "hold down" clips should secure the flashtube
in place. The clips are located under the metal shield.
Flash
Tubes
3 BURNER COOKTOP
13
Air Shutter
Orifice Hood
Two
Tabs
"Hold down"
Clips

Advertisement

Table of Contents
loading

Table of Contents