Advertisement
CLEANING INSTRUCTIONS
1. Remove the Attachments from the Mixing Lid by simply pulling downward on them.
CAUTION! If using the 3 Blade Attachment the Blades are Very Sharp!
2. Cleaning the Mixer should be done immediately after use to prevent food from
drying on the parts. The Mixer should be washed by hand in warm soapy water,
rinsed, then dried immediately. Never use harsh abrasives or pads to clean the
Manual Kitchen Kit.
3. The Mixer can be washed in the top rack of a dishwasher. Carefully position these
pieces where they won't cut or damage other utensils.
CAUTION: Once the 3 Blade Attachment is removed, DO NOT immerse it in water!
Blades should be washed either in a top rack of the dishwasher or by holding onto the
plastic portion of the Blade. With a soapy towel, wipe AWAY from the Blade edges.
To rinse Blade, hold by the Handle and wipe with a clean, damp towel, or hold under
running water. Dry thoroughly.
4.
Store the 3 Blade Attachment inside the Mixing Container. It is safest to place
the cardboard blade covers back onto the blades before storage. Return the Mixer and
all parts to the original box. Store in a cool, dry area. BE SURE TO STORE OUT OF
REACH OF CHILDREN!
When filling the Mixing Container to the maximum capacity,
NOTE:
the weight of the filler might be too much for the Handle to bear. It is
always best to hold the Handle and place one hand under the Mixing
Container for support when carrying or pouring.
WARNING
SHARP BLADES!
Protective/cut-resistant
Kevlar Gloves are
recommended whenever
handling
CAUTION SHARP!
the 3 Blade Attachment!
-8-
MIXER & WHISK ASSEMBLY
1. Attach the Removable Handle to the Mixing
Container. Align the bottom of the Removable
Handle with the "C" shaped handle of the Mixing
Container. Pull up and over on the Removable
Handle to snap the Handle onto the Mixing
Container (Figure A). Test to make certain the
Removable Handle is snug into position on the
Mixing Container.
2. Mixer Attachment or the Whisk Attachment
From the underside of the Mixing Lid, align the
pegs of the Mixer Attachment or the Whisk
Attachment with the slots in the Mixing Lid. The
Attachment should pop into place (Figure B).
3. Align the grooves in the Mixing Handle with
the splines on the Mixing Lid. Push the Mixing
Handle firmly down (Figure C).
4. Place the assembled Mixing Lid onto the
Mixing Canister.
5. The Whisker (Figure D) or the Mixer (Figure
D1) is now ready for use.
Figure D1
Figure A
Mixing Container
Removable
Handle
"C" handle
Underside of
Mixing Lid
Figure B
Slots for Mixer
& Whisk
Attachments
Attachments
Mixing Handle
Figure C
Figure D
Splines
Mixing Lid
-5-
Mixer
Advertisement
