JVC KS-FX385 Instructions Manual page 20

Removing the unit
Before removing the unit, release the rear section.
1
B
When using the optional stay /
Dashboard
Install the unit at an angle of less than 30°.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
2
D
Stay (option)
Fire wall
F
G
H
Screw (option)
C
30
3
Insert the two handles, then pull them as illustrated so that
the unit can be removed.
2
When installing the unit without using the sleeve /
In a Toyota for example, first remove the car radio and install the unit in its place.
Flat type screws (M5 x 8 mm)*
M5 x 8 *
Bracket*
*
Pocket
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If
longer screws are used, they could damage the unit.
:
•
*
•
*
•
*
•
*
*
•
*
•
*
*
2
J
* Not included with this unit.
*
Flat type screws (M5 x 8 mm)*
M5 x 8
Bracket*
*
8
*