Table of Contents
Advertisement
D
Connecting the monitor
Before connecting the monitor, make sure the unit is turned off.
KV-MR9010
9-INCH WIDESCREEN MONITOR
(not supplied)
E
Connecting the external amplifier
You can connect amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Signal cord (not supplied for this unit)
F
Connecting the external components
JVC CD changer
• Refer also to page 15 of the
INSTRUCTIONS.
External component
Set external input to "EXT IN" (see page 24 of the INSTRUCTIONS).
KS-U57*
CD changer jack
AV1-IN
Or
AV2-INPUT
Rear side
Rear speakers
JVC Amplifier
Signal cord (not supplied for this unit)
5
5
Line Input Adapter KS-U57 (not supplied for this unit)
*
Video cord (not supplied)
Remote lead
Remote lead (Blue with white stripe)
Front speakers
*
Connecting cord supplied for your CD changer
*
4
JVC CD changer
CAUTION :
• Before connecting the CD changer, make sure that the unit is turned off.
External component
4
VIDEO OUT
Y-connector (not supplied for this unit)
To the remote lead of other equipment or auto antenna if any
Firmly attach the ground wire to the metallic body or to the chassis
3
of the car—to the place not coated with paint (if coated with paint,
remove the paint before attaching the wire). Failure to do so may
cause damage to the unit.
Signal cord (not supplied for this unit)
LINE IN
External component
Advertisement
Table of Contents
