Note - Panasonic TX-L42FT60B User Manual

Note

TV Guide may also be used to set timer programming event.
●
Watching
Timer Programming
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
For recording using
●
Standby. For reminders to be displayed, the TV must be on.
No other channels can be selected while the recording of
●
Programming is in progress.
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the starting time, a reminder message appears if you are
●
watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
LED will turn to orange in Standby mode if
●
Timer Programming
●
the following occurs:
– You press OK
– The timer programming event that the reminder is set for ends.
"!" identifies that two or more timer programming events are overlapped.
●
USB HDD Rec. is given priority over Reminder. As for the overlapped
recording events, the first event starts and finishes as programmed. The
next event can then start.
The recording of
●
channel to the programmed channel a few seconds before the starting
time.
The recording of
●
Rewind LIVE TV
cancelled.
Recording
For more information of the USB HDD
●
Recording
TV Guide Timer Programming
can store up to 15 events.
only works reliably if correct time information is
Timer Programming, the TV must be either on or in
reminder messages will remain displayed until one of
to view the programme or
Timer Programming
Timer Programming
recording. In this case,
Recording current programme
Technical information
- 85 -
Timer Programming
EXIT to cancel the reminder.
will automatically change the
will be performed even if the TV is in
Rewind LIVE TV
Rewind LIVE TV
Timer
is set.
recording will be