Service Requirements - Mini John Cooper Works Owner's Manual

8. Press the button briefly to change the for-
mat or unit of measure.
9. Press and hold the button until the display
changes.
The settings are stored.
Resetting to factory settings
The settings for formats and units of measure
can be reset to the factory settings. The settings
are stored for the remote control currently in
use, refer also to Personal Profile on page 20.
1. Briefly press the button in the turn indicator
lever repeatedly until "SET/INFO" is dis-
played.
2. Press and hold the button until the display
changes.
3. Briefly press the button repeatedly until the
symbol and "SET" are displayed.
4. Press and hold the button until the display
changes.
Online Edition for Part no. 01 41 2 602 902 - © 08/09 BMW AG Online Edition for Part no. 01 41 2 602 902 - © 08/09 BMW AG
5. Briefly press the button repeatedly until
"RESET" is displayed.
6. Press and hold the button until the display
changes to the first setting.
The settings are reset.

Service requirements

The remaining driving distance and the date of
the next scheduled service are briefly displayed
immediately after you start the engine or switch
on the ignition.
The extent of service work required can be
read out from the remote control by your
MINI dealer.<
Displaying vehicle check
For certain maintenance operations, you can
view the respective distance remaining or due
date individually in the tachometer.
53