Chevrolet 2012 Sonic Owner's Manual page 273

11. Inflate the tire to the
recommended inflation
pressure using the pressure
gauge (H). The recommended
inflation pressure can be found
on the Tire and Loading
Information label. See Tire
Pressure on page 10 44.
The pressure gauge (H) may
read higher than the actual tire
pressure while the compressor
is on. Turn the compressor off
to get an accurate pressure
reading. The compressor may
be turned on/off until the
correct pressure is reached.
Notice: If the recommended
pressure cannot be reached after
approximately 25 minutes, the
vehicle should not be driven
farther. The tire is too severely
damaged and the tire sealant and
compressor kit cannot inflate the
tire. Remove the power plug from
the accessory power outlet and
unscrew the inflating hose from
the tire valve. See Roadside
Assistance Program on
page 13 5.
12. Press the on/off button (E) to
turn the tire sealant and
compressor kit off.
The tire is not sealed and
will continue to leak air
until the vehicle is driven
and the sealant is distributed
in the tire. Therefore,
Steps 13 through 21 must
be done immediately after
Step 12.
Be careful while handling the
tire sealant and compressor kit
as it could be warm after
usage.
13. Unplug the power plug (I) from
the accessory power outlet in
the vehicle.
14. Turn the sealant/air hose (B)
counterclockwise to remove it
from the tire valve stem.
15. Replace the tire valve
stem cap.
Vehicle Care
16. Remove the tire sealant
canister (D) from the slot on
top of the compressor (F).
17. Turn the air only hose (J)
counterclockwise to remove it
from the tire sealant canister
inlet valve (A).
18. Turn the sealant/air hose (B)
clockwise onto the sealant
canister inlet valve (A) to
prevent sealant leakage.
19. Return the air only hose (J)
and power plug (I) back to their
original storage location.
20. If the flat tire was able to
inflate to the recommended
inflation pressure, remove the
maximum speed label from the
sealant canister and place it in
a highly visible location.
10-63