Solmeta Geotagger Pro User Manual page 8

Others
Backlight is automatically on with every button-press. It will turn off automatically after 6
seconds.
Beep tone:
Short press the button for 1 second, and you will hear one beep.
Long press the button for 2-3 second, no beep .
Automatically cycle display in over 3 minutes without pressing button.
LON, LAT, TIM, DIR 2 seconds for one display.
Setting up instruction
Fix the Pro with GPS satellites signal
﹡ ﹡ ﹡ ﹡ To get a quick fix, please take the Pro and your camera to an open outside space and
stand still before connecting the Pro with camera. Holding the Pro in one of your hand
still will enable faster acquisition process.
﹡ ﹡ ﹡ ﹡ Turn it on, then wait for the GPS signal to be fixed.
The GPS icon displayed on the LCD first will be flashing, a flasing GPS icon indicates
that the GPS device is searching for satellite signal, and after a while, the GPS icon
will be static, this means that the GPS signal on the Pro is now fixed. The LCD will
now display related information,latitude, longitude, time, compass heading.
Connecting the Pro with camera
1.Turn the camera off.
2.Mount the Pro onto the hot shoe or attach to the camera strap(see the photo instruction
below)
3. Insert the 10-pin connector of Y-1 into the camera's 10-pin remote terminal and tighten
the locking nut (for cameras with 10-pin Remote Terminals)OR insert the 8- pin
connector of Y-2 into the GPS terminals of Nikon D90 and D5000, be sure that the
connector is in the correct orientation. Do not force the connector and ensure the pins
line up in the correct way. Then insert the mini USB connector of Y-1 or Y-2 into the
USB terminal of the Pro.
4.Turn the camera On, a GPS icon will be displayed in the control panel on top of the
camera, and as soon as the icon will stay steady the photos you are taking will be
recorded with geographical information.
Camera GPS ICON indication
No GPS icon
GPS icon Flashing
GPS icon displayed
Not connected with the camera
Not fixed, signal searching
GPS fixed
8