Lincoln 2007 Mark LT Owner's Manual page 113

Locks and Security
2. Press and release again within three seconds to confirm that all the
doors are closed and locked. Note: The doors will lock again, the horn
will chirp once, and the parklamps will flash once more.
If any of the doors are not properly closed the horn will make two quick
chirps and the parklamps will not flash.
Power door lock/unlock disable feature
The (lock) and
not work from inside the vehicle when:
• the ignition has been turned to the 1 (OFF/LOCK) position, and
• 20 seconds elapse after all vehicle doors are closed and locked using
the remote entry transmitter, the keyless entry pad, or the power door
lock control (while the accompanying door is open).
The (lock) and
• a door has become ajar,
• the ignition is turned to the 3 (ON) position, or
• using the UNLOCK
unlocking via the keyless entry keypad.
Deactivating/activating power door lock/unlock disable feature
All vehicle doors must be closed before beginning the procedure. You
must complete Steps 1–5 within 30 seconds, or the procedure will have
to be repeated. If the procedure needs to be repeated, you must wait a
minimum of 30 seconds to begin again.
1. Turn the ignition to the 3 (ON) position, then press the
three times.
2. Turn the ignition to the 1 (OFF/LOCK) position, then press the
button three times.
3. Turn the ignition to the 3 (ON) position; the horn will chirp to
indicate the driver configuration mode has been activated.
4. Within five seconds, press the
chirps should be heard, indicating the system has been disabled.
Conversely, two horn chirps followed by a honk will indicate the system
is enabled. Pressing the power door
the feature ON if it was previously OFF, or OFF if it was previously ON.
Every two consecutive presses of the
entering the configuration mode will change the enable/disable condition
of the feature.
112
2007 Mark LT (mlt)
Owners Guide (post-2002-fmt)
USA (fus)
(unlock) features on your power door locks will
(unlock) features will work again after:
control on your remote entry transmitter or
control two times. Note: Two horn
button two times again will turn
button after successfully
button