Carrier CT2-29-TV Workshop Manual page 33

2.2.6 Timing Gear, Camshaft and Fuel Camshaft (Continued)
2.2.6.b Injection Pump, Fuel Feed Pump and Speed
Control Plate (Z482- -E2b- -TFX- -1 Only)
(Continued)
When Reassembling
1. Move the fork lever (1) to the gear case side.
2. Hook the start spring (7) to the injection pump control
rack pin (5).
3. Put the specific tool (8) through the fork lever hole of
the cylinder block (9) and hook the start spring (7).
4. Slightly extended the start spring (7) and install the in-
jection pump (4).
Make sure the control rod (6) makes contact
with the idling adjusting spring (2).
Make sure the injection pump control rack pin
(5) engages the fork lever (1).
A length of string passed thru the governor
spring (14) can be used to retrieve the spring if it
unhooks from both the specific tool and the
speed control plate
5. Hook the start spring (7) to the bracket (3) using the
specific tool (8).
6. Hook the governor springs (small and large) (14) to
the governor lever (13) using the specific tool and in-
stall the speed control plate (11). Use copper washers
with the two screws (12) when securing the speed
control plate.
7. Install the engine stop solenoid rod (15) into the guide
of the cylinder block (10) and secure the engine stop
solenoid (16) with hex head bolts.
Be careful not to stretch the start spring (7) too
far or you risk permanently deforming it.
Be sure the start spring (7) is attached to the
bracket (3).
Sealant is applied to both sides of the shims,
gasket cement is not required for assembly.
When replacing the old gasket shims with new,
always replace with the same thickness and
number of gasket shims.
Addition or reduction of shim (0.05 mm / 0.0020
in.) delays or advances the injection timing by
approximately 0.5°.
1. Fork Lever
2. Idling Adjusting Spring
3. Bracket
4. Injection Pump
5. Injection Pump Control
Rack Pin
6. Injection Pump Control Rod
7. Start Spring
8. Specific Tool
2--9
NOTE
NOTE
9. Fork Lever Hole
10. Guide Hole
11. Speed Control Plate
12. Screw and Copper Washer
13. Governor Lever
14. Governor Spring
15. Engine Stop Solenoid Rod
16. Engine Stop Solenoid
62--11161