Advertisement
Multi-Line Music-On-Hold Adapter User Manual
Cordless Phone Set-up
2
step
cordless phones
MOH 500e User Manual 7/03
Telephone Extension Hold Music Activators (TEHMA)
For true "hold button activation" of on-hold audio, each cordless phone requires the
use of a telephone headset (not included) in conjunction with a "hold music activator".
Two hold music activators and headset adapter cables have been included in your
package. If you require additional activators for other phones, contact your
reseller or visit www.onholdplus.com to purchase them on-line.
without activators are able to engage the hold music feature by pressing the
(star key twice)
on the telephone keypad and then (optionally) immediately pressing
the HOLD button on the phone.
Cordless telephone connection
Using the "cordless phone adapter cable (male)," plug the end of the cable with
1
the phone connector into the jack on the hold music activator marked ìBî.
Connect the headphone jack side of the cable to the cordless phoneís headset jack.
2
Using the "cordless phone adapter cable (female)" plug the phone connector side of
3
the cable to the end of the hold music activator marked "A" and then plug the
headset to the other side of the connector cable.
System test
(if test fails, see troubleshooting guide)
From any phone in the office with a "hold music activator" and a headset
1
attached, dial the phone number of another phone (a cell phone works well).
Place the call on-hold using the HOLD button on the telephone.
2
Return to call and confirm that the on-hold audio was present on the line while
3
on-hold.
Using the volume control on the rear of the unit, adjust the volume to proper level.
4
IMPORTANT: Excessive volume will cause the on-hold audio to shut off during playback.
Deactivating hold music manually
If for any reason the hold music is activated inadvertently, it can be deactivated by
pressing any key on your phone's dial pad.
A
TEHMA
P4/2
3
Most phones
**
B
Advertisement
