Checking Wiring And Connectors; Checking Leakage - Coleman F5BMS-C Owner's Manual

3. Put a new gasket on the oil drain screw. Tighten the drain screw.
4. Add the correct amount of oil through the filler hole. Install the filler cap.
5. Start the engine and make sure that there are no oil leaks.
6. Turn off the engine and wait 3 minutes. Recheck the oil level using the dipstick to be sure the level
falls between the upper and lower marks.
CAUTION:
The oil should be changed more often when the engine is operated under adverse conditions
such as extended trolling.
Check that each grounding wire is properly secured and each connector is engaged securely.
Check that no exhaust or water leaks from the joints between the exhaust cover, cylinder head, and body
cylinder.
Check for oil leaks around the engine.
CAUTION:
If any leaks are found, consult your dealer.

3.6 Checking wiring and connectors

3.7 Checking for leakage
34